New low-cost tape sensor 3D printed

posted Aug 9, 2013, 12:08 PM by Tiberius Brastaviceanu   [ updated Aug 30, 2013, 12:43 PM ]

First attempt 

Today Daniel printed the first thing using our new B9Creator. The low-cost tape sensor had the honor to go in first. We are now tuning the printer for better resolution. 


3 prototypes just out of the printer

3D model of this tape sensor on 3D printed device open model

One prototype after cleaning. 

Preparation and calibration of the 3D printer

Further notes

This first design had some problems. See Rodrigo's below.
 
Comments